| Page: |
| Home > General Chat > Need confirmation of centre-distace of inlets on K head | |||||||
|
Forum Mod 10980 Posts Member #: 17 ***16*** SouthPark, Colorado |
4th May, 2017 at 03:28:30pm
Numbnuts here forgot to verify this dimension, and need it asap. Anyone able to cofirm? Easiest to measure over the four and divide to get the number. I know it's a round number - and metric.... On 17th Nov, 2014 Tom Fenton said:
Sorry to say My Herpes are no better Ready to feel Ancient ??? This is 26 years old as of 2022 https://youtu.be/YQQokcoOzeY |
||||||
 2406 Posts Member #: 341 aka T2clubby South Staffs |
4th May, 2017 at 05:32:26pm
70mm rings a bell Dave, I'll be able to check in half hour or so. |
||||||
|
2406 Posts Member #: 341 aka T2clubby South Staffs |
4th May, 2017 at 06:08:34pm
76mm. I nearly remembered |
||||||
|
Forum Mod 10980 Posts Member #: 17 ***16*** SouthPark, Colorado |
5th May, 2017 at 01:02:44am
Thanks, I had 76 in my head - same as the stud spacing (obviously lol) at 86mm / 76mm
Edited by TurboDave16V on 5th May, 2017. On 17th Nov, 2014 Tom Fenton said:
Sorry to say My Herpes are no better Ready to feel Ancient ??? This is 26 years old as of 2022 https://youtu.be/YQQokcoOzeY |
||||||
| Home > General Chat > Need confirmation of centre-distace of inlets on K head | |||||||
|
|||||||
| Page: |