| Page: |
| Home > General Chat > lathe threading | |||||||
 12307 Posts Member #: 565 Carlos Fandango Burnham-on-Crouch, Essex |
21st Apr, 2017 at 12:38:47pm
I need a M20 to 3/4 UNF stud for a hydraluc puller,
On 28th Aug, 2011 Kean said:
At the risk of being sigged... Joe, do you have a photo of your tool? http://www.turbominis.co.uk/forums/index.p...9064&lastpost=1 https://joe1977.imgbb.com/ |
||||||
|
Forum Mod 10980 Posts Member #: 17 ***16*** SouthPark, Colorado |
23rd Apr, 2017 at 12:02:12pm
Pop over this afternoon, I should be able to do it. On 17th Nov, 2014 Tom Fenton said:
Sorry to say My Herpes are no better Ready to feel Ancient ??? This is 26 years old as of 2022 https://youtu.be/YQQokcoOzeY |
||||||
|
Site Admin  15300 Posts Member #: 337 Fearless Tom Fenton, Avon Park 2007 & 2008 class D winner & TM legend. |
23rd Apr, 2017 at 12:41:22pm
Theoretically yes my machine could do it, problem being I've not got any thread cutting tooling, so as I'm sure you'll appreciate it turns into an expensive job. Hopefully someone else will have the appropriate tackle.
On 29th Nov, 2016 madmk1 said:
On 28th Nov, 2016 Rob Gavin said:
I refuse to pay for anything else Like fuel 😂😂 |
||||||
|
12307 Posts Member #: 565 Carlos Fandango Burnham-on-Crouch, Essex |
23rd Apr, 2017 at 02:45:06pm
no problem,
On 28th Aug, 2011 Kean said:
At the risk of being sigged... Joe, do you have a photo of your tool? http://www.turbominis.co.uk/forums/index.p...9064&lastpost=1 https://joe1977.imgbb.com/ |
||||||
| Home > General Chat > lathe threading | |||||||
|
|||||||
| Page: |