| Page: |
| Home > 998cc > Pistons and compression ratio | |||||||
|
81 Posts Member #: 11403 Advanced Member |
1st Sep, 2016 at 02:43:37pm
Are stock flat top pistons OK to use on a turbo build with 12psi max boost ?
|
||||||
 3673 Posts Member #: 9300 Post Whore Quarry Bonk |
1st Sep, 2016 at 05:52:33pm
Yes, along with an intercooler that's fine, 10psi is safe with no intercooler. On 26th Jan, 2012 Tom Fenton said:
ring problems are down to wear or abuse but although annoying it isn't a show stopper On 5th Aug, 2014 madmk1 said:
Shit the bed! I had snapped the end of my shaft off!! 17.213 @ 71mph, 64bhp n/a (Old Engine) |
||||||
|
81 Posts Member #: 11403 Advanced Member |
9th Sep, 2016 at 10:57:18pm
On 1st Sep, 2016 Carlzilla said:
Yes, along with an intercooler that's fine, 10psi is safe with no intercooler. What compression ratio would you recommend for that psi? I have a Suzuki swift intercooler that I was going to use |
||||||
 9258 Posts Member #: 123 Post Whore Betwix Harrogate and York |
10th Sep, 2016 at 10:27:54am
I wouldn't go above 9:1 for any a-series turbo with a steel head. Fastest 998 mini in the world? 13.05 1/4 mile 106mph
On 2nd Jan, 2013 fastcarl said:
the design shows a distinct lack of imagination, talk about starting off with a clean sheet of paper, then not bothering to fucking draw on it,lol On 20th Apr, 2012 Paul S said:
I'm mainly concerned about swirl in the runners caused by the tangential entry. |
||||||
| Home > 998cc > Pistons and compression ratio | |||||||
|
|||||||
| Page: |