Home made Flow Bench - free to a good home
Turbo Mini Forums

Based on this design:
http://dtec.net.au/Flowbench%20Design%20Guide.htm
Built a few years ago for a college course I've cut a couple of heads using this.
Reality is I'll not be using it again probably so its just taking up space.
You'll need to supply a couple of manometers.
It has a couple of hoover motors in it providing the airflow, but like I say I haven't used it for a couple of years now. I did use the vacuum box to create airflow for a small wind tunnel I was playing around with but other than that it hasn't been run.
Located in Northumberland if you're interested. Could possibly take it to Darlington area (where I work).


Hope it can be of some use to someone, or else its to the tip!

I'll take it mate!

I was literally just looking at that guide this week to work out what I'd need to get to build it.

Edited by matty on 28th May, 2016.

https://www.facebook.com/pages/Fusion-Fabri..._homepage_panel

www.fusionfabs.co.uk



1/4mile in 13.2sec @ 111 terminal on 15psi

Message sent Matt.