full turbo project for sale
Turbo Mini Forums

As the title says, im just not getting to spend any time on her lately so have to realize that its time to sell.

looking for £2000 ONO for everything listed below and any bits in the garage that I haven't considered.

interested drop me a message.

car is located in Wigan and will need trailering.

any questions please don't hesitate

http://www.turbominis.co.uk/forums/index.php?p=vt&tid=489679

shell fully rebuilt with



New full floor tig seam welded for extra strength

New inner ( part of new full floor and outer sills )

Tubbed Arches

Roll Cage brace's fitted rear arches

Rear turrets braced across for strength by Vickers

Rear fuel filler hole welded and filled smooth

New rear valance

New rear heal board

Fibre front (permanent)

Beam rear axle

custom rear shelf by Vickers

Customer rear seat squab infills by Vickers

Gaz Coilovers front excellent condition

Gaz Coilovers rear excellent condition

Rebuilt rear radius arms

Rebuilt rear brakes

12" disk setup front ( No calipers )

Adjustable bottom arms( On Car )

Adjustable tie bars ( On Car )

All red anodized red aluminium solid mounts

Turbo box fitted

New scuttle panel

New a Panels

All underside, under bonnet and boot area painted in Grey/Beige Machine enamel for hard wearing

Fiberglass MK 1 boot lid double skin

Lightweight doors excellent condition ( No Windows )

sat on 5x10 Weller wheels and fully rolling



Parts included



1275 engine good condition average mileage ( head removed for inspection )

metro turbo complete with actuator and manifold ( some play in shaft )

Genuine metro turbo carb and inlet manifold and plenum

maniflow downpipe

Twin Ducati 996 rear cans

New fuel regulator

New headlamps H4 conversion

New Mini Miglia wheel arches ( not trimmed or cut )

New plastic bowls and rims

New MK1 Austin cooper grill

New MK1 Moustache

New MK1 whiskers

steering column

alloy steering wheel

2 full looms

all brake and clutch cylinder assembly's

stainless brake cylinder plates

custom center dash with smiths MGB gauges ( all new bezzles and refurbd internals )

all glass

full set of new seals

Nippon denso race alternator

Full Mega Jolt setup including trigger wheel and all edis parts ready to go

New Black lightweight mirrors

Interior Mirror







No interior parts as such but lots of nuts bolts fastening spares etc in boxes



only bit needed for spraying is the door gap on drivers side sorting and boot lid fitting fill and prep and ready for spray.





thanks

I know its probably obvious but you'd probably be better breaking this

13.95 1/4 mile on a 2.95 fd. Carnt be that hard to beat!

shame it was looking a good mini

to bad your so far away

I could organize shipping

Folks please stop sending mails asking to split, I dont have time to do theproject so certainly dont have time to split. If it doesnt go as a project by month end I will probably put on the bay. Sorry but. If I had time to spli I would have time to carry on.
Thanks
andy

ps its a 73 plate with it all logbooks and chassis plates included.

would also take a jetski or certain motorbikes in exchange or paramotoring gear.


Thanks

willing to swap WHY?

so its tax excempt ?

once tested and back on the road it can be declared tax exempt