boost controller
Turbo Mini Forums

Can any one suggest good and easy to fit boost controller???

i do not have ecu :(


i found this one, where you can run 2 boost levels, low and high, have anyone using something like that???

http://www.boostvalve.com/pricelist.html

Nothing special!

Thats basically 2 bleed valves with a solenoid to open and close them.

Its not so much of a controller, it just allows you to change between 2 boost setting at the flick of a switch instead of turning a dial. You can make a similar setup using the standard metro "ecu" (solenoid valve) and a standard bleed valve.

A few people on here are using megajolt to switch the boost levels. This can be configured at set RPMs or Load and is quite a reasonably priced way of doing it.

https://www.facebook.com/pages/Fusion-Fabri..._homepage_panel

www.fusionfabs.co.uk



1/4mile in 13.2sec @ 111 terminal on 15psi