| Page: |
| Home > Show Us Yours! > Turbo Build. | |||||||
 825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
22nd Feb, 2012 at 10:46:44pm
Thanks for that mate.. Alan
On 22nd Feb, 2012 kcchan said: lan
Its all the little bits that make a car like this soo good. Main Build
|
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
22nd Feb, 2012 at 10:52:54pm
Goes like this mate, not finnished other end yet though.. Alan
On 22nd Feb, 2012 george91 said:
Tidy work as usual, looking good. Is the breather going into the rocker cover? Edited by nala56 on 23rd Feb, 2012. Main Build
|
||||||
 478 Posts Member #: 9269 Senior Member Rotherham |
22nd Feb, 2012 at 11:46:16pm
Its all abit to clean for me son Craig
|
||||||
|
1083 Posts Member #: 8932 Post Whore |
23rd Feb, 2012 at 12:01:02pm
No intercooler? |
||||||
 847 Posts Member #: 6673 Post Whore Worral Sheffield |
23rd Feb, 2012 at 08:05:18pm
Could i ask where you got this monkey from? i have being thinking about what to do with the heater pipe work..
|
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
23rd Feb, 2012 at 08:47:52pm
I got It on Ebay Mate, put you the link below.. Alan
Main Build
|
||||||
 6549 Posts Member #: 1149 #1 Basshunter Fan Force Racing ICT Dept Manager Miglia Turbo Am frum Yokshyer tha noes! |
24th Feb, 2012 at 12:08:22am
Id shift your mj from where it is to inside the car. A splash of water and good bye ignition. Looks nice otherwise. 1/4 Mile 14.3secs 96Mph Terminal 10psi of boost.
|
||||||
|
272 Posts Member #: 9125 Senior Member Sheffield, South Yorkshire |
24th Feb, 2012 at 07:33:23am
Llooking good alan. The turbo build has finally started |
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
24th Feb, 2012 at 11:28:03am
Cheers Liam.. Main Build
|
||||||
|
Forum Mod  1927 Posts Member #: 1761 Stalker Bristol |
24th Feb, 2012 at 01:44:11pm
As Mike says, you definitely don't want your MJLJ getting wet as the case is not waterproof.
|
||||||
|
478 Posts Member #: 9269 Senior Member Rotherham |
25th Feb, 2012 at 12:43:18am
Are you ready to get it started yet?
Craig
|
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
25th Feb, 2012 at 09:49:17pm
After putting oil in yesterday noticed a bad oil leak from diff case drive flange, so striped it down cleaned it all up put a new O ring seal and gasket on and seems to be OK now, not done anything today because I’m welding together, a roll over spit for someone On 25th Feb, 2012 dig-mini said:
Are you ready to get it started yet? Did sort the alternator plug? Main Build
|
||||||
 4890 Posts Member #: 1775 Post Whore Chester |
25th Feb, 2012 at 09:51:33pm
I'm not sure the megajolt will like the outside world? I run a supercharger and I don't care the TB is on the wrong side.
|
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
25th Feb, 2012 at 10:15:10pm
Try not to take the car out in the rain, and if it does while I'm out, I put a polythene bag and elastic band round the fuse box and MJ Edited by nala56 on 25th Feb, 2012. Main Build
|
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
28th Feb, 2012 at 12:48:52am
Started the car today and forgot to switch petrol on, so the obvious happened it ran out of fuel which means got to prime the pump again, a real pain so I’ve bought a in tank pump from ebay, waiting now for it to be delivered Main Build
|
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
28th Feb, 2012 at 01:28:42am
Didn’t like this setup anyway..
Main Build
|
||||||
|
478 Posts Member #: 9269 Senior Member Rotherham |
28th Feb, 2012 at 08:55:31pm
My mj as been there for 2 years I'm moving mine when I have to buy a new one Craig
|
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
29th Feb, 2012 at 12:45:44am
Gone back to car today, and it started straight away, not having done anything to it, must have gast it up or something when it ran out of petrol, tried it twice after that started with no problem, will need some tuning now its a bit lumpy on tick over.. Alan Main Build
|
||||||
 1137 Posts Member #: 1450 Post Whore Near Paris - France |
29th Feb, 2012 at 08:48:50pm
Breather through the inlet is an odd idea to me.
Rusty by nature
On 23rd Jun, 2008 paul wiginton said:
They said "That sounds rough mate." I said "Cheers it cost me a fortune to make it sound like that!" |
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
29th Feb, 2012 at 10:55:22pm
The plan is to run into a catcher tank, going to take the pipe coming out the rocker cover down to drop gears breather then tee off into a catcher tank.. Alan Main Build
|
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
2nd Mar, 2012 at 03:42:53pm
Going to catcher tank and then a filter, as for the inlet Idea, It’s just an experiment, no harm done If I have to change It, It’s what we do Isn’t It?.. Alan
On 29th Feb, 2012 Advantage said:
Breather through the inlet is an odd idea to me. I might be wrong but under certain circonstances, I think the coldest part of your breather apparatus is gonna be the inlet and oil dripped down in there is not gonna go anywhere else (I am assuming breather to open air rather than vacuum) Main Build
|
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
2nd Mar, 2012 at 04:25:30pm
OK guys, this is my first start up.. Alan
Main Build
|
||||||
 16540 Posts Member #: 4241 King Gaycharger, butt plug dealer, Sheldon Cooper and a BAC but generally a niceish fella if you dont mind a northerner Rotherham, South Yorkshire |
2nd Mar, 2012 at 04:42:01pm
Sounds good. Is that your sister offering you a coffee at the end? On 11th Feb, 2015 robert said:
i tried putting soap on it , and heating it to brown , then slathered my new lube on it 
|
||||||
|
825 Posts Member #: 9661 Post Whore Sheffield South Yorkshire GB. |
2nd Mar, 2012 at 06:27:15pm
No mate It;s just our Gert Main Build
|
||||||
 2233 Posts Member #: 9037 Post Whore Doncaster, yorkshire |
3rd Mar, 2012 at 05:08:45pm
looks good, whens it ready for the road? Audi s4 b5 - 470bhp & 486ft lbs
On 15th Mar, 2012 wil_h said:
Yes, Carl says he gets requests for rimming all the time On 30th Apr, 2012 Brett said:
yeah stick the bit in and give it a wobble  |
||||||
| Home > Show Us Yours! > Turbo Build. | |||||||
|
|||||||
| Page: |