Clubman take 2
Turbo Mini Forums

I have allowed for the tire etc, as above, the photo is with the top arm all the way down. When the coilover is bolted up the arm sits much higher and clear of the wheel.

This shot better shows the clearance with the coilover compressed

Started on rebuilding the inner wing area for the coil over brackets to mount to.






Got this far then ran out of wire, hopefully complete it tomorrow



Had a little mock up with the arches too..

ooof that looks low and phat.

Medusa + injection = too much torque for the dyno ..https://youtu.be/qg5o0_tJxYM

Tasty!

Perfect

Yes i moved to the darkside

Instagram @jdm_brett

looks awesome low.

What the mind can conceive the mini can achieve
MITP 2012 17.01 seconds 1/4 mile against "The Don"
MITP 2013 16.83 seconds 1/4 mile

Cheers chaps, that is at full bump so it won't be quite that low all the time.

always been a sucker for low minis and mig arches, it just looks right

Yes i moved to the darkside

Instagram @jdm_brett

Genuine carbon fibre mig arches

What the mind can conceive the mini can achieve
MITP 2012 17.01 seconds 1/4 mile against "The Don"
MITP 2013 16.83 seconds 1/4 mile

Little update

Been trying to get the underside finished, and do any jobs that are easier whilst it is on the spit. All the floor and boot floor has been POR15 coated, and I have been finishing off suspension brackets etc.

Also been working on the read diffuser and exhaust arrangement, still some fine tuning to do but its getting there.

Took it off the spit and got fully rolling for the first time, next job is make the front brace bars before paint prep begins.










Its currently sat on the bump stops, and the boot floor is not fitted. All being well I can make some progress soon, if time allows..

Nicely done.

Yummy!!

Nice work mate

Looks pretty mean... What wheels are these?

that diffuser looks the part.

you can do anything if you set your mind to it...
i rather blow it up winning than keep it together losing.

finish date set for project 1... march 2018

PH phat!

I run a supercharger and I don't care the TB is on the wrong side.
VEMS + 12 PSI + Liquid Intercooler = Small Bore FUN!

Thanks guys

Wheels are mini specials split by Mr Austin, 10*7

so much like !!!

Yes i moved to the darkside

Instagram @jdm_brett

Finally got round to doing some more work, including ordering the front end and initial fitment..

Done a little bodywork on the de-seams, knocked up the brace bars and made a few brackets etc, nothing much exciting for now..

Looks nice & angry!

Looking like a hill climber!

Good looking project. Followed you in IG for a while but didn't know you had a build thread.

Just wondering, do you know how it will handle with that wheel and tyre combo?

IG?